Step 1 :
Connect SAPIDO device with your system and choose a wireless network .



Step 2 :
Give default IP 192.168.1.1 to web browser.


Step 3 :
Put username (admin ) and password (admin) on login page. Then click login.

 

Step 4 :
The page show the current status and basic settings of the device.



Step 5 : 
From the Menu select operation mode and choose one of the mode from three and then apply change.

 

Step 6 : Select AP mode if there is already router connected with ADSL/ Cable Modem, you can choose AP mode to turned wired internettothe wireless.



Step 7 :
On selecting the AP mode the settings for the AP mode will appeared and then click on next.


Step 8 :
The page show the current status and basic settings of the device

Step 9 :
Select WiFi AP from operation mode.When an AP exists, you can extend the wireless coverage with WiFi AP
mode.

 
Step 10 :
On selecting WiFi AP the settings for the WiFi AP mode will appeared and then click on next .



Step 11 :
You can change the time zone and device setup in the WiFi AP mode.


Step 1 2:
For the wireless security choose one of the encryption


Step 1 3:
After update your all settings device interface will be logout then you have to mannually login again.


Step 1 4:
Select Router from operation mode. If you connect a 3G modem card to the 3.5G server for Internet surfing, please choose Router mode. Multiple PCs can access to Internet under Router mode. Router mode works with not only DSL, cable modem, but also hotspot.


Step 1 5:
On selecting Route the settings for the Router mode will appeared and then click on next .


Step 1 6:
Select the time zone as your requirement.


Step 1 7:
You can change your device name and IP address.


Step 1 8:
Fom the WAN setup you can change the WAN interface .


Step 1 9:
Select LAN from IP config to change the setting for IP address,subnet mask,DHCP etc.


Step 2 0:
Select wireless from the Menu and choose basic settings as the network requirement.


Step 2 1:
For the wireless security choose one of the encryption.


Step 2 2:
From the system managament you can upgrade the firmware to new version.


Step 2 3:
Choose a file and then upload it.


Step 2 4:
In the log and status select network config to know the current status and basic setting of the device.